Diamond Replacement Heads

Grinder Comparison Chart
These heads fit .312" (7.92 mm) arbor

Heads are usually interchangeable with all grinders.
Consult your individual grinders documentation for shaft size & head compatibility.

Inland Heads
Good Quality, Less expensive Heads

Glastar Heads
Longer Lasting heads

1/4 Inch Grinder and Hole Drilling Head
Fits all INLAND and Glastar Grinders

Item #WB-8 .... Price: $16.95 Each
Quantity

Drilling Bits: Start by holding the glass at an angle to the top of the bit with
a sponge held against the bit and the underside of the glass. As you grind,
work the glass around the point of contact. It’s important to keep the bit
and glass wet. Frequently, remove the bit from the hole to wet the hole and
remove residue. Just before the bit comes through the glass, decrease
grinding pressure to prevent chipping.
View Image

Inland Bit

Glastar Bit
& Adapter

3/4 Inch Grinder Head
Fits all INLAND and Glastar grinders. Just Added

1 Inch Grinder Head
Fits : Wiz* , Twin Spin and the Wizard Grinders Twin Spin and the Wizard Grinders
& Glastar G4, G6, G8 Grinders
(*must use bitsert that comes with Wiz grinder)

Item #GS-9(s/f) ..... Price: $34.95 Each
Standard Fine
Quantity

Just added
1" 60 Grit Fast Cut Head
Item #GS-960..... Price $44.49
Quantity

**Do you need a replacement head for a G-5 Starlet**?
**5/8" Standard Grinder Head for Glastar Model G-5**

Specialty Bits
	Ripple/ Fuser Bit The RippleBit™ from INLAND removes texture from glass edges making them easier to foil or lead. The RippleBit™ is great for tapering the edges of heavily textured glass. It grinds the top and bottom of the glass, allowing it to fit into lead came or metal channels. Use this bit to thin textured or thick glasses, to fit lead and metal cames, or to make pieces easier to foil. Taper the glass edge and remove texture by passing it through the groove in the bit. Item #WB-1R ..... Price: $34.95 Each Quantity
	LampBit™ The LampBit™ from INLAND miter grinds your lamp pieces for a better fit and more professional looking solder seams. The LampBit™ is used to grind lamp pieces to fit on a miter. The bit is reversible, with one side at a 9 degree angle for 20 panel lamps, and the other side at an 18 degree angle for 10 panel lamps. Use the side that comes closest to your lamp. Item #WB-18 ..... Price: $34.95 Each Quantity
	Jewelry Bit 220Grit - Twofers From Aanraku Includes two bits. Make a small groove in the side of glass for attaching wire, etc... Item AA-12 ..... Price: $24.95 Quantity

Like all Inland bits, the brass cores are manufactured on "Swiss precision" machinery for consistent and accurate tolerances.
Bits are measured for true before the diamond is applied, so the bits spin properly on the motor shaft.

IMPORTANT! Always use safety glasses when grinding.